How to wire Profiler -> Palmer Macht 402 -> Marshall 1960AV

Hi everybody!

I finally decided to get a profiler with an external power amp and it will arrive shortly.

But I'm not sure how to set it up...

My Setup will look like this:

- Kemper Profiler (unpowered)

- Palmer Macht 402 Power Amp (https://www.palmer-germany.com…amplifiers/5188/macht-402)

- Marshall 1960AV (https://marshall.com/marshall-…abinets/1960av-and-1960bv)

How Do i set it up properly without damaging everything?

Kemper Main Outs to Mixer (if possible, sometimes in small clubs we play instruments through Cabs only or even share backline.)

Kemper Monitor Out -> Palmer Input -> ?

Thanks for any help. I didn't find any useful instructions yet...

Edit: I found the manual of the Palmer Macht 402 online!

There it says: Bridged Mode - 16 Ohm - 200W

So i can put in into Bridged Mode, dial my cab on 16Ohm and then it would be

Profiler -> Palmer Input A -> Output A(bridged) -> Cabinet

and that's it, right?

Thank you for the answer!

The Profiler arrived and i had the opportunity to test the Rig in my practice room and it worked fine. Now I just need to tweak my tone and then start profiling myself. But it was good to know, that i don't need to worry about damaging my cab.