Hello everyone!
I was wondering if anyone could help me; I purchased an RME card recently (AIO pro) and for the life of me I cannot figure out how to get a signal from the spdif input of the card.
I tried figuring it out with the help of the manual and I can use the breakout cable of the card to connect from spdif out coaxial of kemper to the spdif in (manual says the white RCA input is an spdif in).
I have done this successfully with my focusrite interface (not using anymore - it's a firewire interface) and even reamped successfully but with the RME i am not looking to reamp atm, just get a signal and record.
The problem is unrelated to the DAW setup though, as I am not getting a signal in totalmix fx. Also it does not seem to detect kpa as master clock. set it up at 44.1khz but nothing.
Below are a few pictures of my settings (although I tried different settings to no avail)
Would really appreciate some help