Kemper newbie here so sorry if this is a basic question. I picked out all my rigs to fill out about 4 performances and then started programming them. While in Perf. 1, I decided the rig on button 2 didn't have quite enough gain, so I turned up the gain for that button and pressed "store". I then found that the gain had also been raised on button 1. I couldn't figure out how to go back to square one, so I rearranged the performances in Rig Manager, reassigning Perf. 1 to Perf. 50 or something, just so that I could have a blank performance to work with in spot 1. But it's still giving me problems. I found the perfect profile for button 1 in Browse mode, but when I stored in in Perf. 1, button 1, it sounded completely different. To make sure I wasn't going crazy, I toggled back and forth between Browse and Perform several times and, sure enough the same rig sounds very different in the two modes. Any ideas what the heck is going on?
Thanks.