Remove feet from KPA Stage?

    I know that there is a venting hole in the bottom of the KPA Stage - and this would keep clear!


    BUT: can you remove the feet from the KPA Stage and reuse the screws without damaging anything?

    Want to include the KPA Stage into my Pedalboard (yes using some stuffe beside it) and am not sure if I would damage it when reusing the screws that hold the feet - they might be too long?


    Any experience?


    I used black perforated tape (Hanger Strap) on my remote. Cut the perforated tape about 3 or 5 holes long and screw it under the rubber foot. Then screw the protruding tab onto the pedal board. That's how I did it also with my Cry-Baby.

    Be the force with you ;)

    Like 1