Profiling Q

    Do you guys pay special attention to the initial profile you are dialed into when ready to start capturing a new profile from an amp? I understand if you are capturing a distorted or clean tone, its best to start with the same, but is there one profile that you will always start with being clean or dirty, and does it make a difference?

    The starting Profile has no influence on the outcome - it is only recommended to select one so you can
    a) listen to the Profile and compare it to your setup before Profiling (and maybe adjust the mics a little etc) - so you have a frame of reference

    and

    b) to save time when tagging

    Quote from DonPetersen

    The starting Profile has no influence on the outcome - it is only recommended to select one so you can
    a) listen to the Profile and compare it to your setup before Profiling (and maybe adjust the mics a little etc) - so you have a frame of reference

    and

    b) to save time when tagging

    Thanks, was just wondering if it had any influence on the profile.