Possible to Daisy Chain 2x12 Kemper Kones with 1x12 Kone, from Powered Toaster?

I have 2 Kones arriving Monday which will go into a 2x12 cab, wired in Series as per the manual, for an 8ohm total rating.

I also have an empty 1/12 cab lying around not doing anything.

So I was curious, could I get another (i.e. 3rd) Kone, put into the 1x12, and then daisy chain the 1x12 (4ohm since single Kone) to the 2x12 (8ohm since 2 Kones in series).

Speaker out from powered Toaster will go into the 2x12 cab, which has dual input jacks (input jacks would be wired in parallel currently but I could change that to series I believe?), and then daisy chain to the 1x12.

Impedance mismatch problem?

Is above possible without damaging toaster and all kones involved? Whether it will sound any good is another matter of course!

Thanks!

Quote from paults

If you properly wire everything in series, total load = 12 Ohms.

So meaning the KPA would be "happy" with that since it falls within the 8 - 16 Ohm recommended range?

Quote from Sollazzon

Despite the indication near the output jack, .... it's also ok a 3x12 of 12 ohm.

Ah, perfect! thank you for clarifying that!

Quote from Burkhard

However, if you run one Kone in series with two other Kones in parallel, their volumes won't be the same - I believe.

I believe I should end up with all 3 kones being in series. 2 in a 2x12 are in series, and the third kone in a 1x12 cab daisy chained also in series. So I should in theory get (somewhat) even volume (discounting for now the fact that 2 are in bigger cab, and 1 is in a smaller cab)?

Quote from Hurricane

Thats Right. All 3 Kones Running in Series will get the Same ammount of current. Volume differencies then only depend on the cabs

thanks for confirming!