Where do you guys keep your Main, Monitor, Direct and SPDIF Outputs?
How should I set it if I want to run through my Kabinet and also main output into my computer/monitor speakers?
How do I control the volume going into my computer/monitor speakers?
Main, Monitor, Direct and SPDIF Outputs
- PrivateGuitar
- Thread is marked as Resolved.
-
Where do you guys keep your Main, Monitor, Direct and SPDIF Outputs?
Main Outs L&R <----> Interface Ins L&R (lines 1 and 2) using TS cables.
Direct Out <----> Interface In (line 3).
Monitor Out <----> powered floor monitor.
SPDIF <-----> Interface SPDIF.
How should I set it if I want to run through my Kabinet and also main output into my computer/monitor speakers?
Interface Outs L&R <----> L and R studio monitors.
Power Amp Out <----> unpowered Kab (power amp when using a powered profiler).
Monitor Out <----> powered Kab (or separate power amp + unpowered Kab).
How do I control the volume going into my computer/monitor speakers?
You can set the studio monitors rear volume control to about 80%+ volume. Then control overall volume of profiler and the Audio Interface with their respective volume knobs.
-
If I'm going into my Apollo Twin, which option would this be?
The Apollo Twin only has 2 inputs and 4 outputs so you can only go Kemper Main Outs L&R <----> Apollo Ins L&R (mic/line 1 and 2) using TS cables. You don't need XLR cables for this.
Apollo Twin has no SPDIF so no use going there. You can buy a separate optical-to-SPDIF converter but that might open a can of worms.
Apollo "Monitor(s)" labeled L&R <----> L and R studio monitors.