I am using the powered rack and unpowered Kabinet with proper speaker cable plugged into the red output of amplifier and 'in' of kabinet. I've combed the entire output menu -Kemper Kone and powered amp enabled. Other than an audible click at power on/off -no sound. Please advise.
No sound from Kemper Kab
- dirtfoot
- Thread is marked as Resolved.
-
Connections are right. Did you try to increase the monitor output volume?
-
On Page 8 of Output menu with Kemper Kone enabled Monitor volume set at maximum -0.0 db. No output. Headphones work -when I plug it back in.
Strange. Mine is super loud at 0 dB. I usually keep my monitor volume around -10 to -12 with the Kab.
-
are you using the right input? some times, you accidentally plug your guitar into the headphone out. happened to me too
-
no iota I have everything set to max. The speaker only sounds during powering on and off, and enable/disabling of power amp Page 9. This is a used unit/Reverb and I have creeping feeling that it will need servicing.
If you hear a slight "pop" from the Kabinet when you power on and off the power amp then it sounds to me like the power amp is working. At 0.0db the Kab should be friggin loud! I have my power amp volume down to -64db which is talking volume. My Main Volume and Headphone volume on Page 2 of Output menu is =13db for both.
You may need to open a support ticket.
-
What is the “Input Source” for the Monitor Output?
Also, if there is an active Effects Loop in the Rig, disable it to eliminate it as a possibility. -
Thanks paults. Page 1 on Output Source - Monitor Output was off. Time to celebrate and get another Kabinet. Thanks guys!
Hooray!