I own the Kemper Stage for two weeks now and am of course struck by the possibilities, but also very enthusiastic.
I used to play over two amps with the TC Electronic Mimiq Doubler to create a guitar wall because I'm the only guitarist in the band.
Now I've tried to recreate it with the Dual Chromatic Delay or the Dual Delay, but I have the impression that it sounds a bit phased.
So I hung the Mimiq Doubler in the Effect Loop. Now, however, I have the problem that I always have a small sound dropout when I switch rigs in performance mode.
For the sake of testing, I once copied a rig with the effect loop switched on and switched it back and forth. There is often a small dropout (of around 8 ms) in the delayed signal, accompanied by a crack. It doesn't matter whether I use the lower loop or the upper loop.
I tested it also with other pedals (a delay and an EQ). I don't have a sound dropout here, but I can hear a distinct crack.
It's wired correctly (SEND 2 to the pedal, from the pedal to RETURN 3 and 4) and I've tried other cables as well.
I then hung the mimiq behind the main outs. That works of course, but I would prefer to go into the mixer with the XLR outputs when we play live. In this case, I would also have to get two DI boxes so that I can supply the mixer with a line signal.
Does anyone have another tip? Thank you and best regards!!