Main Output?

    Are you able to connect from both .." The XLR and TS-jacks" at the same time?

    So either one goes to desk, and the other to eg: Seymour Duncan PowerStage 700 to run stereo guitar cabs?

    Kind Regards

    You have a choice of XLR (balanced) or quarter-inch TS-jacks (unbalanced). :?:

    You theoretically could use both pairs of physical outputs simultaneously, but you couldn't control their signals differently e.g. volumes.


    In your case - if you intend to use guitar speaker cabinets - you need to deactivate the cabinet simulation in that signal, while the cabinet simulation must be included in the signal for the mixing desk. The MONITOR OUTPUT is prepared for that puspose. With Monitor Cab. Off you can suppress the cabinet simulation just for the MONITOR OUT. If you don't own a PROFILER Stage model and intend to run two guitar speaker cabinets in stereo, activate Monitor Stereo in the Output Section and use DIRECT OUTPUT for the other channel.


    This subject is covered in the Main Manual by the way.