This is my first attempt at profiling anything so any help is really appreciated. How do I properly connect my Kemper stage to the Fractal? I plugged my guitar into the Kemper and sent the main out R to the front of the Fractal. The R main out from the Fractal is going to the return of the Kemper. This isn’t working at all. What am I doing wrong? Thanks in advance.
Help with profiling an Axe Fx II Patch/Beginner Advice Needed
- FireInside
- Thread is marked as Resolved.
-
-
Connections for PROFILING an AXE FX.
• Connect your guitar to the Input of the PROFILER.
• Connect the DIRECT OUTPUT or SEND 1 from the PROFILER to the appropriate input on your AXE FX.
• Route the output of your AXE FX to the RETURN or RETURN 1 of the PROFILER.
✓ Be sure to disengage the noise-gate in your guitar amp simulation software before PROFILING it. Turn off any time-based effects in you AXE FX.
-
on the astage you need to use Send 1 into Fractal and Fractal out into Return 1 on the Stage. Download the Main Manual from the Kemper Website and there is a whole section that explains the process fully.
-
That worked! Thanks for the help, I appreciate it!