Yesterday I installed Rig Manager Version 188.8.131.5257
and using that I installed OS 184.108.40.206267B on two Profilers (unpowered Head and PowerRack)
I noticed that both Profilers left in Browse Mode will freeze up* after a couple of hours, left unattended. This has happened in as little as two hours but earlier today, both were fine for four hours. If it matters, they are both connected via USB to the same PC running Rig Manager.
I haven't been able to actively play either Profiler for very long (removing from a hand injury), so I can't tell if the units will freeze up if actively in use.
* freeze up = unresponsive. If I turn the chicken head knob from Browse to Perform, nothing happens at first. Then the Remote reboots, but finally I have to turn the chicken head knob off and back to Browse to get things working again.
Has anybody else noticed this?
I have reported this to Kemper Support with a link back to this discussion.