I have just started working with the iPad app in my Kemper rack setup. Data connection is ethernet cable from Profiler to an internal LAN port on a Netgear access point, ethernet from a second port to the input of a D-Link power injector with Kemper floor controller cable plugged into the output. Everything basically works, but after connecting the app I'm finding that rig switching within a performance is very sluggish, as is the profiler response to EFX buttons on the floor controller. Is anyone else experiencing this? I'm at the latest release firmware.
Very slow rig switching when using iPad app
- vtgearhead
- Thread is marked as Resolved.