Keep tremolo (spillover) when I change rig?

    When using delay&reverb, I use spillover on DLY&REV stomps to keep the delay&reverb tails going when changing rigs.

    I can 't do the same with the tremolo.

    Is there any way to be able to do this?

    Excuse my english.

    Thanks

    Delay and reverb can be made to 'spill over' since they propagate the signal by delaying and repeating it (as a simplification).
    An amplitude modulation (Tremolo) doesn't do this - it is instantaneous.
    What you could do to made things smoother when transitioning from one rig to another is to use the morph feature and have the Tremolo Mix lowered by the morph.

    I imagined. When I reduced tremolo with the morph I perceived a change in tone. Today when trying it again I have seen that this happened due to the volume in the tone effect. I have adjusted this volume so that the change is not noticeable with or without tremolo.


    To reduce the tremolo to zero with the morph I simply turn the "stereo" parameter from 0 to 180 and the effect disappears, since I play in mono.


    Thank you very much for your help