Hello,
I've been using my Kemper for a long time as studio hardware, but mostly using clients profiles. I did just a couple of low gain profiles until today and everything was apparently right. Today I tried to do a high-gain profile from this chain:
Kemper -> Peavey 6505 -> Mesa Boogie 4x12 -> 2x SM57 -> Lynx AD Coverter -> Cubase 11 (1.5ms latency) and mix the two signals -> Lynx DA Converter -> Kemper
While I listen to the reference amp (the 6505) it sounds supercool, so I go for the profiling, and after that the result is like distorted, like if I would have cranked my pickups up, and adding a lowpass. When I'm in the last page and do some refine, it is still the same, and so different from the original. Trying the A/B here in the last page is like day and night.
I already checked:
- No pedal ON in the new profile.
- Incrase/decrease input level and/or the output from my computer.
- Add/cut some latency.
Any thoughts here?
Thanks in advance!