Footswitch leds

Quote from mattclarkmixer

I’ve noticed that if I’m on a preset and I press the same preset’s button again it will toggle the led next to it. There’s a top and bottom led. What is the purpose of that?

Tia

I recommend you to download Main Manual 8.5 and check it 1st. Regarding your question you can start at the bottom of page 56 (Stage) or page 287 (Remote).

Morphing.

As vjelen said, the manual will explain it fully not yhat you know where to look.

You can program two effects to one switch.

Quote from BayouTexan

You can program two effects to one switch.

indeed you can, in fact you can assign more than two fx to a single switch but only two will have LED associated with them. However, the OP is asking about the bottom rig switches rather than the FX switches.

My bandmate footswitch light is flickering while we are playing.. So we switched pedals and my pedal works fine on his setup. When hooked up to my rig, it was fine for a bit until it started to flicker a little bit.. Is this something that needs to be sent back for repairs or what are your suggestions? It's brand new and its hooked up the powered rack version.

Quote from SOTL777

My bandmate footswitch light is flickering while we are playing.. So we switched pedals and my pedal works fine on his setup. When hooked up to my rig, it was fine for a bit until it started to flicker a little bit.. Is this something that needs to be sent back for repairs or what are your suggestions? It's brand new and its hooked up the powered rack version.

Submit a support ticket and Kemper will help troubleshoot. No way to really tell what the problem is without some diagnostics.

Quote from mattclarkmixer

I’ve noticed that if I’m on a preset and I press the same preset’s button again it will toggle the led next to it. There’s a top and bottom led. What is the purpose of that?

Tia

it’s to do with morph settings. Really useful feature. If you haven’t programmed any morphing the you probably won’t notice a difference in sound.