Torpedo Captor X noise gate warning when profiling

  • Mucking around using a Kemper Rack to profile my Dirty Shirley head through a Torpedo Captor X. The noise gate in the Captor X is disabled. After profiling, I get a warning that a noise gate was detected. The resulting profile is lower gain than the reference amp, even after refinement.

    As a troubleshooting step, I connected a cable directly between send and return and profiled the cable. It resulted in a successful clean profile without the warning.

    I know others are using a Captor X to profile, but I haven't heard reports of them getting the noise gate error. I've opened a case with Kemper support and am waiting to hear back, but I'm curious if anyone else has experienced this issue.

  • I see this is an older post but I just saw the same thing.

    I'm running a Sol Invictus pedal into a Mesa Mark V power amp into the Torpedo Captor X. I just hit OK but I noticed a lot of the low end seemed to be missing when comparing the profile to the Reference amp.

    Not sure if you resolved this or not?