Hey there good people. I’ve tried figuring out what is wrong with my setup. I want to connect an external drive pedal in the FX loop of the Kemper. I mainly use RM to navigate. I have some issues. Nothing happens with the sound.
My connections:
- Kemper return input to pedal output
- Kemper Direct output/send to pedal input
I select a slot in RM and have tried to chose all three loop types. I get this warning in the RM: “Insert loop effect disabled. Monitor output is set to stereo and aux is in use”.
What does that mean? I went to the output page in RM and tried changing Main Output from stereo to mono and Monitor output which is off was turned on in both stereo and mono. Nothing changes.
I tried to change AUX input in the Output page from stereo to mono and that’s where the last part of the warning appeared. Up until then it only stated the first part. I changed the AUX Input back to stereo and it stays the same.
Last time (a couple of years ago) I connected an external pedal it was pretty much plug and play. I don’t get what is going on here.
I hope someone has some helpful insight on this issue.
Thanx in advance 🙂