Hey good people. I’m very embarrassed to admit that yet again I struggle with reamping through S/Pdif. I’m just not good friends with the reamping game apparently.
My Kemper settings:
Input: S/Pdif input Reamp
Output: Git/Master mono
Freq: 44.1kHz
My DAW: Cubase 10
DI track: Output set to S/Pdif left
Track for reamping: Input set to S/Pdif Right and output set to Master Out in Cubase.
Freq: 44.1kHz
Interface: Babyface Pro FS
Windows 10
S/Pdif cables both correctly connected.
What I read from the manual the left side carry the DI signal and the right side carry the reamped signal. So I guess my input/output choice on the tracks in Cubase are correct.
When I hit play I see the volume meter bouncing on the DI track. But there’s no sound. The track for reamping is armed for recording. And it doesn’t matter if I have the monitor on or off on this track. If I press monitor on at the DI track the volume meter stops bouncing. I cannot hear either the DI signal or the reamped signal. The reamped signal does not enter Cubase.
The S/Pdif connections are fine. I can record both the DI signal and the distorted signal at once.
What the heck am I doing wrong?