Perfomance mode problem

Terrapin · Jan 19th 2023

Hello all,

I’ve searched high and low regarding this issue to no avail and I’m hoping that somebody can help me out with this..

I’ve set up a performance where I have a clean sound in slot 1 and a crunch sound with some stomps in the off position in slot 2.

Now, I start the song with the clean sound in slot 1 for the verse. When it comes to the chorus section I switch to the crunch sound in slot 2. I turn on various stomps during the chorus and return to slot 1, The problem comes when I go back to 2nd chorus (Slot 2 crunch sound) and all of the stomps are still ON.

Is there any way I can program the remote to keep the stomps OFF when I return to slot 2?

Kind Regards, T

Kemper Support #1 · Jan 19th 2023

disconnect Rig Manager. As long as the Profiler is connected to Rig Manager it will be in edit mode and all temporary changes are preserved.

Wheresthedug · Jan 19th 2023

as support said. When you have rig manager connected the KPA thinks you want to edit settings so doesn’t revert to previous version as it assumes you are only comparing something and don’t want tomhave to male all the changes all pver again when you return.

Terrapin · Jan 19th 2023

Thanks guys, that worked perfectly!

Share