You create a Performance and have one part the "Solo". Easy enough.
You can't morph an effect if it's not on. Like I said, if you want to have those 4 different tones and go from one to the other quickly then Performance is where to do it.
You can't morph an effect if it's not on. Like I said, if you want to have those 4 different tones and go from one to the other quickly then Performance is where to do it.
That would work if there were 8 peformance slots. Each of the 4 tones I want to have a boosted lead with alternate delay.
Is there any way to have morphing activate and deactivate an effect?
Not that I know of. To accomplish this I just change the mix of the effects, pretty much the same result. You could use more than one drive, but I know that takes up another effects slot.
Not that I know of. To accomplish this I just change the mix of the effects, pretty much the same result. You could use more than one drive, but I know that takes up another effects slot.
this. I have all the fx on and morph the mix. I also boost amp volume 3-5 db.
Im trying to set up morphing so that when I hit the button it automatically turns off my reverb, turns on my delay and increases the mix, and also turns on my Drive pedal. Is this possible?
what is “increase the mix” doing in this scenario? If you are toggling between Rev and Delay they can each have the correct mix as default so no need to increase the delay mix when morphing.
If you don need to morph a value you can simply assign a single switch on the i - iiii row to turn off rev/on delay/on drive.
delay block on/off and mix on the morph. Exactly how I use it. What is the issue?
You could accomplish this using 2 delays on separate blocks. Also I believe you could do this with one block, you would have the 2 morph settings you want & use one of the fx control switches to toggle on/off.
You can morph the delay mix using the Rig button (1, 2, 3, 4 or 5. Whichever one is active), setting the morph rise and fall to zero. The button can also be set to momentary (press and hold) or latching (on/off). Note the two LEDs stacked above each rig button. Normal, the bottom is lit. Morphed, the top.
You can assign the delay on/off to one of the 4 stomp buttons above rig buttons 3, 4 ,5 and Tap.
delay block on/off and mix on the morph. Exactly how I use it. What is the issue?
because I can't have it on slot one with lower mix and off and higher mix on morph and be on.
im guessing this is only possible with two delay blocks
need to switch on before to morph, not an issue....
Do you mean this?
Do you mean this?
I thought of that but the problem is I can't use the effects as an instant access switch/effect while not in morph mode. at that point they're completely disabled in that preset. Sometimes I may just want to kick in a drive pedal for more gain without having all the extra effects change like it does in morph mode.
need to switch on before to morph, not an issue....
trying to avoid the tap dance and accomplish it all with one button
trying to avoid the tap dance and accomplish it all with one button
Then the easiest way is to set a separate rig in the next slot
There are so many performance slots available, why not just make another slot with what you want. Why limit yourself to being stuck in one performace slot (or as I'm used to calling the them - presets).
