Help: Kemper Stage takes unwanted audio signal from PC

Hello everybody,

Since a recent update of the Kemper Stage, my audio setup isn't working the same as previous.

While the PC (Windows11) audio signal is connected to channel 1 on the mixer using USB, the Kempers signal is on channel 2 (Jack).

But, when I have connected the Kemper to the PC using the USB cable, the Kemper takes the PC audio signal and is routing it together with the guitar signal to channel 2 on the mixer. Channel 1 is dead at that time. A mix between PC audio and Kemper audio is no longer possible. As soon as I have disconnected the Kemper USB, everything works as it should.

Am I too stupid to handle or are there some settings, not found yet?

Thanks for any hints,

Solved, the problem was, that Kemper was set as the Standard Audio device. Setting up the normal USB on the PC as Standard-Out will solve the problem.

Thank you very much for your much appreciated support and have a good time.

Cheers,

Pascal