I have some problems to set up the pedal range for my Ernie Ball EB6180 VP-JR when using a wha pedal in the Kemper.
The touch mode is not working...
I usually set the pedal to "bypass heel"
Then it works, but not over the complete range of the ernie ball pedal.
only the upper part, like from 90 to 100 %, and it is not very usable like this...
I tried to play with the pedal range and peak range, but can not find how to use the complete pedal range of the ernie ball...
Is anyone else using a Ernie Ball EB6180 VP-JR?
Wha range settings
- krikke
- Closed
- Thread is marked as Resolved.
-
-
It took me an hour or so to setup my GCX switcher with the Ernie Ball, and it's working fine now...
The Ernie Ball in the #1 pedal input is not working properly... -
i have the same problem. is there any way to calibrate the pedal on the kemper. so 0% = 0% and 100% = 100%. now it is 90% = 0% and 100% = 100%
-
Have you tried "Pedal Init" in system menu?
-
You will never have good results with the earny ball, since it's not a dedicated expression pedal, unfortunately.