Posts by mvg2405

I'm playing with a boost stompbox activated in a EVH 5150 III performance. This boost is directed from the B knob on the Kemper in the stomp section. In this setup the boost stompbox setting is using pedal 7 on my FCB1010. I'm using the uno4kemper chip with midi in and out. So I can turn the boost on and off.

Is it possible to have the boost setting on without having to use up a pedal on my FCB1010 pedalboard?

Can I edit a performance with effects so that the default performance is with the effect on, without actually having to use the stompbox section?

Thanks for the tips Burkhard.

A little while ago I send an email to the support of the fcb1010.eu guys who sell the Uno4kemper chip, with the question if they were still active, because their website isn't updated in months. To this day I didn't get a reply from them.

Can you tell me if they still exist? In that case I will buy that chip right away.

For now I have the original Behringer chip.

I did check the midi messages and with my little knowledge of midi I think it only sends one message to kemper.

My initial idea was one amplifier clean/crunch/high gain. The FCB1010 has 10 pedals right? So I assigned pedals 1/2/ 3 as clean/crunch/high gain

But if you want to implement for example the wah on the clean/crunch and high gain, I reckon you have to go to 4 (clean+wah) 5 (crunch+wah) 6 (high gain+ wah). Because as far as I know you can not activate and stop the wah (as using it as a stompbox) on the first 3 pedals.

So what I ment was that if I go higher than the fifth slot, thus to pedal 6, the Kemper has to go to a new set of slots. So when I activate the sixth slot it has a very noticable and annoying lag.

Was trying to find an answer, but I can't find anything current on the subject. Mostly I find threads dating back to 2014 and some even 2012.

When in performance mode I have latency switching performances higher than the fifth performance slot on the FCB1010. This way the Kemper isn't usable in a live situation.

I read an answer dating back to 2014, the guys at Kemper had this issue at high priority, but I guess they didn't fix it yet??

(Jul 21st 2014- Quote from ckemper :The improvement of the rig switching time has always been on our todo list. Since other important features are about to be finished, this topic has rised to a top position on the list )

I have updated to the latest OS and factory resetted the FCB1010.

Anyone have a useful answer?

thanks.