I have a Boss WL-50 wireless system with a DC-IN and DC-OUT Jack.
Current Draw is 320mA (When Charging) and it is 9V.
Can I connect the Power Supply of the Kemper (9 Volt 2.5A 22.5W) to the Boss DC-IN and then with the DC-OUT to the Kemper Player (Voltage: 9-12 DC, 24 W) both + outside / - inside?
Europe, so 230V.
Posts by Jazzyybass
-
-
Kemper support reply:
I have crosschecked with the OS 8.6.6 and it looks like a software-based issue.
I have informed the development about that. -
For everyone works the "phaser oneway" perfect?
-
Hello,
after the update yesterday the phaser oneway isn't working as before.
Not as smooth and there is a sort of "bump"in the sound.
Am I the only one?
(Stage with all the latest software)
-
I want the Aux In function to be used to feed in a band monitor mix from a mixing desk, mix it locally with the guitar signal and, monitor the sum via in-ear monitors connected to the HEADPHONE output.
Is there a way to EQ the headphone mix and not the MAIN out?
-
Or you can profile a patch cable (from send to return) to get a totally transparent Profile with the added benefit of the great AMP parameters like Definition, Compression, Clarity, Pick etc.
-
I use the M. Britt 56 Twin from the Tweedy Pack for that.
-
thank you...I think I used the wrong search words in the manual.
I hoped that there was a way to switch in one performance and keeping the chosen effect buttons.
-
Hello, I think I miss something.
If I use (for example) Rig button 1 (clean sound) and add Effect button I (chorus), then for the solo I go to Rig button 5 (overdrive) and go back after the solo to Rig button 1, the effect button I is off (as stored).
Is there a way to remember the last setting?
Thank you.
-
Thanks - what's the Mesa range?
Frequency range: 80-5000Hz
-
I have a Fiore and noticed no difference with my Fender Clapton custom shop strat.
I use MBritt 2020 Pack profiles...63 Vibroverb, 68 Mars and 72 Mars.
My high and low cut is set the same as my Mesa Boogie speaker freq. range.
-
Hello,
I assigned button B to the looper switch, but the LED under the switch is not working when pressed.
Is there a way to get that working?
Thank you,
Rob