A new kind of specific filter Low/ Hi Cut to use without EQ parameters.
Posts by Snake Eyes
-
-
Another interesting point, I tried to put into the Kemper my Fulltone OCD, and it sounds terrible, is there any kind of “special” adjustment to do it?
The OCD sounded completely different of a conventional amp.
-
Hi,
An update here, I improve a bit with bass/high cut configuration, and input sensitivity.
Please Kemper team, pay attention in this thread, the shredders needs your help.
-
More one here!
I like a lot to play shred stuff, but is very complicated to find a useful tone, it is strange because is great to hear when I strum it, but bad to play solos.
I have tested all the suggestion that I saw in this thread. If someone have an another idea please comment.
-
Display More
Hi,
I've recently purchased the Powered Kemper Kabinet which I have connected to the Monitor Out on my rack Kemper.
I'm experiencing some horrible high frequency distortion with many of my profiles. I have the "Monitor Cab Off" enabled in the Output stage. Changing the imprint does have mixed results, but doesn't ever truly rid this harshness (although changing the imprint would not be a good enough solution anyway)
I am only detecting this with my Strat and its largely on those profiles set around breakup. My 335 does not appear to have the same problem, but could simply be my bad ears. I have a 25db mid boost circuit in my Strat, and with that higher output, again the problem is less pronounced.
I've experimented with the "Clean Sens" and "Distortion Sens", and although in some combinations it does reduce the problem, it is still there.
Some profiles seem fine, all AC15 and AC30 profiles are good for example. My JTM45 profiles seem to be the worse, but the problem is certainly not limited to these.
I have not detected the problem using my Studio monitors (Main Output running into my audio interface); it just seems to be when running through the Kabinet.
Your help and suggestions will be very gratefully received.
Thanks.
I have exactly the same problem... My hi gain profiles sounds bad, I will try to contact the support about it.
-
Yes, I have the same problem with my kemper stage...
