I was wondering if there are plans to make LP for bass? I got a few bass amps i personally would like to have LP of.
AD200 from Orange
The classic Ampeg head And a few of the rack mounted ones
Hi-watt 200 (probably not a bass amp as such, but sounds good)
That would be a good start i would think IMHO
Of course this makes sense.
It seems you drive the Profiler’s input a little too hard.
I did drive it to hard, no question about that.. I just didn't know or understand how the clean sense worked apart from that it leveled out the volume of clean and distorted rigs.. Thanks
Display MoreThe led changes from green to red ... so in between right before clipping would be yellow ... so in the worst case aka by hitting hard it would not clip ...
I does not hurt to try to change the input sense and see how it behaves !
Good luck
Raf
Thanks.. Got ot to work...
yes that makes sense.
Clean Sense is a strange, often misunderstood, hybrid control. It sets input gain and balances the level between clean and dirty rigs. I think I remember ckemper saying that the KPA uses a limiter on the input to achieve the level balancing but I can’t remember the details.
I don’t know whether it is all software or a combination of software and hardware but you sometimes need to lower the the clean sense drastically to get good results. In my case (guitar with medium output pickups nothing particularly hot at all) I need to lower clean sense to around -6db all the time to get a decent balance between clean and dirty rigs. I seem to be pretty unique in this respect though as most people get good results at 0. Which is why I wonder if there is some hardware involvement rather than just software which would be consistent across all units.
Thanks, it made sense in the end
My input light peaks when i adust the bass and treble on my bass, i talked to support, they said that i had to adust the clean sence til it was showing a yellow light when i hit hard. does that make sence?
I've hass issues when booting up, it boots up, when it's done booting up it stays on the KPA logo. I did that hold down the system and rig button and start it up inn tuner mode, it looked like that was the fix, but the day after i had the same problem.
It does not happen every time, but it's a pain in the a#@ when it happens, and it's not even a year old..
Support ticket opened
I also got a little problem when booting up, sometimes when it boots up, everything looks like its doing it's thing but when it's done booting up, the only thing that's displayed are the KPA logo.
Did that press and hold the system and rig button while starting the KPA up in tuner mode, It looked like that was the fix, but the next day the same problem resurfaced.
I did send inn a support ticket.
