In the forum there's a few profiles of the Rusty Box that is a preamp of this amp. Haven't found any but interested too.
Posts by BabyDracula
-
-
Does it actually kink up, or roll up and lay like a mic cable? Or a guitar cable?
mine is pretty much like an XLR cable.
-
https://www.amazon.com/dp/B01G…dt_b_product_details&th=1
I bought a shorter version of this and have had no issues.
-
Swapped wires around and was able to get it to go. The cable isn't bad, but I guess the kemper doesnt like it? Did have to set the return to -30db to get it to work though.
-
I should have mentioned this in my original post:
- All effects are OFF
- Noise gate(s) are OFF
- I am only profiling an amp and a cab - some have an eq cut before/after a cab but result is the same whether its on or off.
- Happens on both clean or dirty profiles
- Not a huge amount of gain going on and profiles don't sound "noisy"
- No matter where I set the output level (either on the amp, on the cab, on the output or in settings OR lower the return on the kemper), I get these messages.
Not sure what I'm doing wrong, but I am a newbie to this.
-
I've read some posts talking about this, but I can't seem to get this to work. I get "amp is too noisy" or "Amp is too low" and I've decreased the output and the return volumes and it's either one or the other. It happens on clean and dirty profiles. Was just looking to capture a sound so I could use it in my bedroom. Any help or links would be appreciated.
I did a forum search but couldn't find anything, maybe I was searching the wrong terms?
