this one is funny...
Posts by luntho
-
-
GHS Boomers 9-46 or 10-46...sometimes ernie ball same gauge....have used elixir coated a few times but they cost like 3 sets of boomers
-
found this clip on YT,
-
I have the same problem...I got the id14 a few weeks ago and did a short attempt reamping but as I remember my problem was that I couldn't get the di signal out through output3 only...it was always present in all outputs... I will try to find the time to get it working...after all the 4 outs was the reason I sold my old id 14 and got the new version2 for reamping.....I'll follow this thread with great interest...hope you get it sorted out.
-
I have the qsc k10 as well as the yamaha dxr10 and headrush 12...the headrush was my favourite until I got the kemper kab. didn't like the qsc at all but when used with the helix stomp it sounds great..much better than all the others... but for the kemper I would go for the kemper kab no doubt.
-
it's possible on the toaster so it must be on the rack too
-
thank you
-
Thank you!
-
-
I have alot of MB-profiles and they are a bit dark compared to many others ...until you crank the volume to live-levels...try adding some treble/presence and definition or switch to a brighter cab.
-
totally agree.. btw, what is your "go-to-cab" ? commercial profile?
-
I have only used my cab in my homestudio (6m x 5m) so far but with cab-volume at 1 o´clock and pushing the monitor volume up to like -2 it gets VERY loud ...
-
I've never cared much for fuzzpedals but now I suddenly do
...the preset called "preamp" is very useful in alot of my rigs ..love it -
really nice profiles, thanx!
-
thanx
-
Hey Brianllun,
Just noticed same issue, turned out my reference pitch was somehow set above 440Hz. Dialled it back again and happy days!
This has happened to me a number of times in the last couple of years...usually it changes to 439Hz and sometimes when I change it back to 440 it jumps back to 439 again after a few seconds ...
-
most of the cabs I use come from studio profiles (non-merged) ...whatever sounds good...
-
thanx alot
-
I bought this one and it sounds good with my marshall 2x12, more than enough for a full band rehearsal. I haven't used anything else so I can't say how it compaires to more expensive units.
-
I noticed there's a hi-z input and 2 mic-inputs on the soundcard...How do you connect the kemper to your soundcard?
