make a backup, open it on PC with Total Commander, cancel from the content all things that you want to get rid of and restore that backup. FX and Stomp boxes cannot be canceled, only the presets.
Posts by guitarnet70
-
-
When not active the latency is automatically kept at the lowest (but variable) possible value depending on the DSP load. Very good playing live, less when overdubbing (phasing), therefore the option for a constant (but higher) latency is available for recording purposes.
-
...anyway the answer is 1.0 CS and 0.0 DS
-
All those tones depends so much on your guitar/pu/finger/pick that I'm afraid it would be very difficult to help you out unless somebody here knows you and your playing that well to make an informed guess... Start playing around with reference amp profiles and tweak from there.
-
Look, there are a lot of profiles made in the early days when people was still trying to figure out how the get the best out of the toaster. Some of them is average and some is still exceptional (Till's ones, the Morgan AC20, the Egnater Tourmaster, the Engl Morse.....and so for.). Call it luck or whatsoever but they are part of our story and what is crap with an EMG equipped ESP maybe is golden with a 335.... If it takes 280 clicks to find what you're looking for....well, that's part of the journey, IMHO. I'm still glad that it doesn't takes 28 amp purchases anymore...
-
I don't even get near to orange with my LP with BB3 and CS at 0.00 db....
-
Welcome!
-
Awesomeness!!! like always...
-
Bring some clean pants with you....
-
Search for Piezo in the Rig Exchange. The new Factory Content has also some Acoustic Rig.
-
well....the Rig volume, down right on the front panel....
-
Yiiiipppiiiieeeeee!
If there is anything that you cannot figure out you'd better PM us, otherwise you're going to get a lot of crap here....
-
If the direct out is clipping check the volume. ..Output menu (Master for the white one)
-
It could be an issue of the Uno4kemper FW...log this issue with support, please, and include a backup copy.
-
Go to page 6 of the system menu, check the wha to pitch case, activate the pitch and check out if the 2nd bar (cc04) is moving accordingly.
-
Is the same pedal working properly with other functions (wha, volume...any other pedal controlled fx)?
-
Don't believe is going to make anything out of deleting the user settings, in this case. If it happens again the OP should make a backup while the failure is on and send it to support.
-
I just tried it. I do get some low volume crackles (measured around 18-20db lower as the main signal) just when sustaining the sound WHILE changing rig...and to be honest this is something that I never do....but you're right..
-
does this happen with all rigs? How are you switching (browse knob, arrows or controller)? I cannot reproduce it here...
-
Everybody here should be very thankful to Andy...I am by sure.