Use the RIG keys on the right. You can also use the PAGE keys.
Posts by timo
-
-
Just drag & drop the Effect Symbol of the slot to a folder under "All Presets".
-
This is the MIDI indicator, indicating that the Profiler is receiving SysEx commands voa the MIDI ports.
-
You can only edit both end values. If you want to edit the resulting morphed value, the editing would be ambiguous: do you want to adapt the lower or the higher value or maybe both? It is not decidable.
it could display the value, but I don‘t know how useful this is. -
As described in the Rig Manager Manual (Help->Manuals->Rig Manager Manual), Chapter "Rig Editor", Section "Edit Morphs":
Edit Morphs
To make a parameter morph, simply hold "Command" on macOS and "Ctrl" on Windows while changing its value. As you can see, this creates an increasing span between two colored dots. The orange dot represents the toe position whereas the blue one shows the heel position. To change the toe value, release the option key. To reverse the position of the dots and therefore reverse how the parameter will morph, drag in the opposite direction.This is immediately followed by the section listing the key commands you might find useful.
-
This is a feature. The Profiler preserves your current edits - even when not saved - over a power cycle (or power failure).
To discard your edits, just reload the Rig in question. -
Please update to the latest release 7.3.2
-
Please update to 7.3.2.
-
There is no change in recent OS versions regarding this.
In the browse view use the Rig buttons to change the entries, use the PAGE buttons to skip sections.
-
you're receiving a response for your request.
Sending that response back to the profiler sets it again.
-
The acoustic simulator will be an effect type.
-
Open a support ticket and tell them from which version to which one you did upgrade! You are probably running into a feature? Let support help you to figure it out.
-
The Rig Exchange content is counted as well for "All Rigs".
Every installation of RM comes with a snapshot of the current Rig Exchange content. Sometimes, users that contributed retract or update the content in the Rig Exchange and this can be the reason why the total number of rigs on "All Rigs" may change. Also, the number can change during sync with Rig Exchange or connected/disconnected Profilers.
-
You should contact support directly.
-
Use Rig Manager 3 to convert IRs.
-
With Rig Manager 3 you can directly create Cabinet presets. Drag & drop the IRs on a Preset folder to convert them.
In the RM 3 manual you‘ll find detailled information about this process.
-
No, the Input Section does not indicate the ‚E‘ (at least in OS 7)
-
This still works. In the Rig Browser you use the page buttons, on the normal Play page you can use the rig cross up/down in Browse Mode to jump „sections“
-
The TAP button on the Remote can be changed in functionality - please check that it is assigned to work as TAP.
-
Yes, this is being fixed in the next version,