Posts by MG-Chris

  • Profiler Remote - Tap light NOT blinking

    My tap tempo light on my remote doest not light up or otherwise blink at all. It's set to the correct function in System > Remote setup. It does allow me to tap, but the LED doesn't blink at all. I was watching a related outube video (and noticed that this fellow's tap light on his Remote is blinking in sync with his head.


    Where do I enable this setting? I can't seem to find it in the manual or in the system pages.


    Related video is this one:


    External Content www.youtube.com
    Content embedded from external sources will not be displayed without your consent.
    Through the activation of external content, you agree that personal data may be transferred to third party platforms. We have provided more information on this in our privacy policy.

  • Kemper remote freeze/connection

    Was this ever addressed? Happens to me as well, new Kemper remote. I'm in a home studio, I always use Rig Manager so my laptop is always connected. Even with the laptop sleeping and the USB cable connected to a hub, the Kemper (rack, non powered) freezes with the USB cable connected. if I disconnect the Remote or the USB cable the head unit starts responding again.


    Edit: Updated to the latest FW. Now it hangs when I switch from Perform to Browser. Unit is locked up completely and has to be hard power cycled (pulling the plug). This is less than ideal.

  • Power Rack - Monitors + Cabinet simultaneously?

    This is probably a no-brainer but I don't see it at a glance at the manual and figured I'd ask at the risk of looking silly...


    I currently have a Profiler head, non-powered, I'm considering picking up a powered rack version to replace it. One of the my favorite things about the KPA is that it's no-nonsense. Right now I have it cabled to my interface (Apogee Ensemble) which runs to my monitors, and everything sounds fantastic. I can flip through presets at random without having to make any changes on the KPA itself and they all sound great.


    What I'd like to do (and am hoping the power rack will get me) is have a KPA cabled both to my interface (with the cab and power amp simulation all enabled) and to an external "real" cabinet at the same time without having to swap cables around and/or edit presets all the time to make sure that the cab sims aren't being sent to the actual cabinet.


    Is that possible with the profiler rack? Or will there be a lot of cable swapping and whatnot to pull it off? Thanks!