Have you checked your input settings? Browser and performance mode have separate input settings.
Edit: looks like @Ingolf beat me to a response.
Have you checked your input settings? Browser and performance mode have separate input settings.
Edit: looks like @Ingolf beat me to a response.
Check this link to see if you are having the same issue:http://www.kemper-amps.com/for…rough-SPDIF-reamp-solved/
@djemass - thank you. I give them a try later tonight.
Dunlop DVP3 here as well.
added: Rig Manager is able to adjust real time clock
My Kemper clock seems to lose time. This Rig Manager update automatically corrects the Kemper clock when I start RM.
@Grooguit & @digbob - I'll let my setup 'idle' some today to see if I can duplicate. I usually let mine 'idle' with expression pedal at toe, I'll try heel position.
Edit: After sitting for 2 hours in heel position, everything functioned as normal when going to toe position. Sorry, can't duplicate with my setup. Best of luck finding the source of your issue. Please let us know if/when you find the source.
From your description, I would suspect cable (guitar to m5), the m5 or cable (m5 to Kemper). Your description of the tuner engaging with the expression pedal sounds like the pedal, Kemper and remote were functioning properly. The remote does not have any input signal passing thru it so I don't see how the remote could be the source of the problem. By your description, you were not getting an input signal. This implies gear in front of the input jack (assuming levels are set properly which you described as being so). Troubleshooting issues which heal themselves can be very difficult to resolve unless they stay in this mode until the issue is found. Best of luck.
@djemass - glad to hear that you have decided to still hang with us. Your handling of this unfortunate incident is a demonstration of your good character.
settings are: rate 0.42, depth 5.5, manual 2.7, feedback 0, peak spread -5, stages 2
used between distortion and stack
Thanks, I'll give this a try tomorrow.
@sledge76 - that's the best univibe sound I've heard from the Kemper. Care to share your settings?
Very generous. Thank you.
I can not understand Kemper don´t have a solution for this problem.
They do have an answer...it's called performance mode. Performance mode was designed and maintained for ----> performances.
Browser mode has more delay when switching rigs than performance mode has. Are you in browser or performance mode when you experience a 'delay'.
http://www.amazon.com/dp/B00GYHHQ78?psc=1
1 foot long. Looks to be better quality.
http://www.zzounds.com/item--HOSCSSR?siid=133999
This looks cheap, but is probably good enough for a pedal cable with no sound going through it.
+1 to the Dunlop DVP3.
Welcome. Good to hear you are enjoying the Kemper and Bert's profiles.
You're an asshole trolling. You should get banned for this.
@AlienSexGod - I don't care what your motivation was for your comment, my vote is that you get banned. There are a lot of conversations tolerated on this forum, but this one crossed the line (and then some).
@Maurizio70 - very nice. It's obvious that you spent a lot of time getting this organized and set up. Thanks for sharing. Well done.