Posts by Kemper Support #1
-
-
4.06 public beta has just been released. This version fixes a bug that is related to wrong data being loaded into a performance after a restart.
-
Have you checked which view you have selected on your Profiler as i advised you in response to your ticket?
Make sure that "All Rigs" is the selected view. -
The ground lift for the main outs only works for the XLR outputs and not for the TS outputs.
-
No problem-i already forwarded your question regarding Undo to our developers
-
As i already mentioned in my answer to your ticket-if you have any specific questions feel free to ask them. I will forward them to our developers.
-
Der Grund warum der Wert des Rig Volume Parameters bei allen Werksrigs auf 12 Uhr steht ist es dem Anwender möglichst viel Spielraum nach links und rechts zu geben, um den Wert zu ändern. Es spricht nichts dagegen diesen Wert zu verändern, um z.B. Rigs in der Lautstärke aufeinander anzupassen. Im Gegenteil-genau dafür ist dieser Parameter gedacht.
-
A performance will always have the first slot enabled. You could turn down the rig volume for the rig in that slot to enter a silent performance.
-
hallo...
weiss jemand ob das USB Kabel beim Kemper im Lieferumfang sein muss.?
mein Kollege hat eins bei seinem Kemper dazubekommen.
bei mir war leider keins dabei. Sieht aus wie normales Kabel für einen Drucker ..USB/Ethernetwäre sehr dankbar für einen Tipp
Gruss Andi
Ein USB Kabel gehört nicht zum Lieferumfang.
Wahrscheinlich hat der Händler das Kabel von sich aus dazu gegeben. -
You can set the location and the range of the volume pedal independently for each rig in the rig menu. If you want to have the same location and range for every rig you need to use the lock vol pedal function in the same menu.
-
The placement of the monitor is up to you.
-
You could try using a small active monitor on stage that you feed from the monitor out. Controlling the monitor out level with an expression pedal will allow you to bring in the feedback when you want it.
-
Does it happen with all rigs?
If it only happens with certain rigs please check the Panorama paramter in the Rig menu. -
Auf der Volume Pedal Seite im Rig Menü gibt es die Option "Lock Vol Pedal". Wenn die aktiviert ist gilt alles wasansonsten auf der Seite eingestellt ist global für alle Rigs.
-
Activate the lock function for the effect that you want to make global. All changes to the settings of a locked item will apply to all rigs in your performances.
-
The ports on the Profiler are not intended to be used to power or charge any thirdparty devices.
Any potential damage that might be caused by using the Profiler outside of its specifications are not covered by your warranty. -
The Remote can not be purchased separately at any retailer. It is only available as a separate item in our online shop.
-
Please try to load one of the Wah presets by turning the browse knob when you look at the wah edit page.
-
Please wait for the 5.0 version of the Profiler operating system which will include a variety of new delay algorithms including the Crystal delay.
-
I was stating that a Shimmer effect will be part of a new upcoming firmware (5.0 I assume) along with all the other new delays. It was demonstrated in videos I have saw from Namm and was also available briefly by accident via a couple of rigs that appeared on rig exchange.
Was just letting the OP know that this feature will be coming to our Kemper.
The effect that you are referring to as "shimmer" is probably the crystal delay that was shown at NAMM.