Yeah, where is the Kemper Editor? Seriously, the lack of an editor in 2017 is an embarrassing stain on this otherwise wonderful piece of gear.
Posts by buddachile
-
-
-
-
I've asked for this before and I'm asking again.
-
Very nice profiles. Up there with the best of them.
-
From reading the addendum 3.1 document it seems to me that PureCab has no effect when it comes to creating a profile. It seems to be some kind of adaptive notch filter applied to the final sound of the stack.
-
Right, Sony took it down because of all the money they'd lose from that cover being available for free. Geesh.
-
The bottom track (purple) has a bit more bass response. Not saying which is necessarily better, It's a pretty subtle difference because it's not in the main part of the tone.
-
+1 I want an editor. For the record...
-
I just bought these profiles. They have a good frequency balance, well mic'd. I've only played them today but so far I like them a lot. Much better than the AFD100 and YJM100 profiles in my opinion.
-
If you're looking for a more transparent compressor then the compressor stomp, please try the Compressor parameter in the AMPLIFIER section.
Nice suggestion!
-
Thanks for these and all the other profiles. I find the GRStudios profiles to be among the very best. If you were located in Los Angeles I would be asking you to profile my amps! I like the way you mic the cabs, which is such a big part of a recorded guitar sound.
-
Wouldn't it be cool if you could load a cabinet (from a preset or rig) to be applied before the Kemper's main output so that you could monitor the DI+cabinet when making direct profiles? You could easily tailor the settings on the amp tailored for the sound of that cabinet. If the cabinet used to monitor was stored with the profile it would be even better.
I will be surprised if this can be done in a firmware upgrade, but if it can I think that would be an awesome feature. Doesn't hurt to dream.
-
I really want to use Rig Manager to manipulate Cab Presets. I want it bad.