Any news on that? Would love to have a High pass in the Output section!!:)
What's official recommended for using the unbalanced Direct Output (at Git Studio) & Recording guitar DI's with it??
No one here use the Direct Output straight for analog DI Recording? TS to DI Box? If, let me know what cables you prefer to use please, thanks
Have to say,It works like charm for recording the DI of Direct Output(Git Studio) with TRS-XLR and later Re-amp to KPA Return Input!
But Iam interested in the technical background of the Direct Output and using TRS instead of TS Unbalanced.. maybe someone can clear that for me
Hello, I see in the manual etc stated that the Direct Output is a unbalanced Output (Low impedance).
I want to set this on up for Guitar DI recording straight to my Interface (+4dB Line Level XLR Input) so I set my Kemper Direct Output to Git Analog to the signal up to Line level, now the question should I go for
1.just TRS from Direct Out to Interface XLR
2. or TRS - XLR cable and
better Re-wire the TRS side??
The connecting cable have the cold signal conductor of the cable tied to ground at the source-side only (the unbalanced end of the cable). The load-side of the cable will be connected in a typical balanced configuration
What you guys can suggest me to make it right,
Iam not too much a tech guy,the kemper specs and discuss in forum about the Direct Output confusing me a little.
Without Cab selected?
With cab selected, if you want "recording ready" sounds.
Hey man, what you especially meant with recordinng ready sounds?
Oh since when Kemper people Tell this NO Refining? Which Fw?
Hey guys, can you give ne some advice for profiling a pedal like the Sansamp Tech21 Bass Driver DI ? Are you profile CLEAN or DISTORTED, depends right? Without Cab selected? Refining it?
Sorry for asking, I haven't profiled a lot with my Kemper so far, and never a Bass rig.
Would be great to get some tips before!
Ok cool brother,Thanks for the reply.yeah they sound really good.Pricey too but if they are releasing more profiles for these packs and then you can update the packs you bought then it is worth it.
That's what I thought too for sure!
Hmm perhaps contact the Seller, I payed 20 GBP in PayPal, so about 28 EUR. They just released Amp Profiles, im looking forward to check them later today!!!
Thats the layout I will take for my own shirt
I will check this again tommorrow at any rate,
thx for the reply's,
Im on Mac Yosemite by the way
...I don't really get what you mean, honestly.
What I ment with the restart, was that if you copy merged rigs to the kemper from the rig manager, you have to restart to kemper in order for the new rigs to be visible in the amp browse menu.
Sorry, yes thats what I ment too in the end
Damn, hope they fix this soon, well Im not sure of it's this bug.
for example you have an Merged Profile selected also over the rigmanager, nothing locked. Then load another DI Amp Profile in the rigmanager, so in the kemper. Then select the Amp Button in your actual Merged Profile and want to browse to the Amp tothe imported DI Amp Profile, it's not in the list.
First when power Off and On the Kemper again
Maybe it's because of the bug you told,
Just load in the RM, so in the Kpa
Or is this fixed already? Im not at the newest firmware in the Kpa.
Thanks for the answers guys, so I always done it right already, but wonder about the lock feature now thats why asking better
you know what is annoying, if I load a new Profile or DI Amp Profile in my kemper with the rigmanager, if I want to browse to this Amp then, it's not there to pick in the list, i have to make my Kpa Off and On, then it's available,