Following this. Interested to see if Fender has addressed the hiss on the production side. So much good information here and on the link provided, Thanks.
Posts by teleplayer364
-
-
Thanks for the reply, I might look into that. Won't be an easy task. I wonder if anyone else has encountered this problem?
-
Hi, I built a patch panel for my Kemper Rack that has the Main outs, monitor out and Direct out on it. When I mounted the RJ45 ethercon cable jack to the same panel there is a digital noise that is coming out of the monitors. I tried the ground lift (really didn't expect it to work but why not try?). If I isolate the jack off of the patch panel it is dead quiet, but once I ground the ethercon panel connector with the remote cable attached it comes back.
Anyone else have this problem and found a cure? I could mount another patch panel on the back of the rack probably and put the connector there( the other one is on the front). But was looking for other possible options or ideas from the group as I'd like it in the front. Many thanks!
-
+ 1 Had this happen to me once also.
-
Interesting, I was just coming here to see if anyone is having problems with their switches. One of mine feels like it is about to go bad and would like to get it replaced. I would like to just get a couple switches shipped to me and have it done locally. Two are clunky and noisy.
-
I run the panning at 9 oclock and 3 oclock.
-
-
Thanks for your reply. I haven't been using it in the mains, but one of those thing that seems to not be clear on its use.
-
Just wondering how you guys set your space function in the output section. Do you have the Space>HeadphOnly box checked or not? I assume that if the box is not checked the space function also affects the main outs. If it is checked it only works with headphones. What is the consensus on how much of this effect do you use? Thanks!
-
Same problem here. Done it twice and still have that prompt every time I open rig manager.
-
I also leave the switches in the middle position. I think that the tone is better with the DSP off.
-
The Victory Silverback profile is sweet! A lot of clarity for that amount of gain.
-
Any love for the Victory Silverback profile loaded up by the boys? I'm digging it.
I must be awful at finding this stuff. Is it on the rig exchange? I couldn't find it.
-
Pull up the video in this thread with Chappers and Lee and underneath the video on YouTube is a link to the that profile.
Thank you!
-
I've found that about a 4db boost works good for solos. Also with some of the gainer stuff I might boost the mids a bit. Let us know how it went.
-
Trying to find the SW 22 profile on the rig exchange with zero luck. I've searched under morgan lee, Danishpete and a few other versions of these. Can anyone help out? Thanks!
-
I also use a lot of the MBritt profiles and they just work in the mix. I made the mistake of using headphones to tweak my profiles. Much better to tweak them w/ monitors. I also started with guitar cabs but found to get the best tone out front the FRFR route worked better for me. I use the DXR10's after trying a few different setups. This ended up working the best because what I'm getting out of the monitors is really close to what is coming out of FOH. I did some dialing in on the FOH with guitar cabs, but it was trickier and less consistent. Easier for me using monitors that are similar to FOH. Of course YMMV.
-
Finally had a chance to check them out. Found two that are really nice. A fine example of a traditional Fender clean and slightly pushed. Thanks for sharing them.
-
When it happens again I guess I will record it and open a support ticket. Seems as only one other person has had this problem it must be a problem with the unit.
-
Thanks Ronald V. I will look into this.