In der Überschrift steht es ja schon drin:
was genau ist "Ducking" bzw. was genau kann man damit machen?
Posts by music
-
-
To be honest: I don't like the naming of the profiles.
Isn't there a way to name them much simpler to identify? -
@Eltzejupp:
Found you on Sounccloud.
Thanks!
What rig did you use for the beginning Strat Solo in the Song "Satrianis until we say goodby improvisation"? -
+1 for guidorist and sinmix
If you are a strat player bert meujlendyk is top of the list.
Only my two cents and i have tried a lot of commercial profiles. You can hear some examples on my soundcloud.
Link belowcheers
FrankUnfortunately there is no Link!
-
-
Video gesehen, kurz gekotzt und dann gelacht.
Was für ein Schwätzer. Der hört sich gerne selber reden! -
Had the same problem here.
FCB1010 is used.
Same response of Kemper support as most of you.
Seems to me that the problem is caused by the following (maybe only in my case):
I switched off the Behringer Midi Device, Kemper was still on.
The Kemper usually needs some time to realize that the Behringer is off (after realizing there is a small message).
But: I turned off the Kemper before it could realize the switched off Behringer.
Next time I started the Kemper (and the Behringer was still off), the Kemper didn't find the midi device and crashed.
That's my theory. -
More stomp/effect buttons =>
-
-
I am waiting!
-
Meanwhile the Kemper stars regular. I did nothing but trying to start over and over again.
So far, so good.
But if the error occurs while a gig?
Not good! -
No Firmware update.
Just a regular start of my Kemper. -
Support already contacted.
-
Does anybody know this starting error?
And if so, where/what is the problem? -
-
-
Einen ähnlichen Fehler hatte ich auch. Dazu hatte ich ein Support Ticket aufgemacht, aber nach zwei Neustarts war der Fehler nicht mehr reproduzierbar.
Das war die Nachricht an Kemper:
"If I switch on my Kemper, no matter if I switch to Tuner, Browser or Perform, after booting there is the Tuner and no more reaction of the Kemper!
No matter what I switch to, no reaction of the Kemper, only the Tuner is visible.
I don't want to loose my rigs and performances!
What can I do?" -
Is it only made for use with InEars or also for the use with regular active cabs?
-
Is there a general setting which works for most of the profiles I could use?
-
Can somebody please explain: what is pure cab?
(I'm not experienced, sorry for not knowing this)