Posts by Pneumo

  • Mic preamp?

    Using a microphone preamp will change the profiling results, but in addition to the changes caused by the preamp, there may also be an impedance effect...

  • Power Cable Effects

    >Monkey_Man

    Thanks to your reply, I was able to acquire new knowledge.

    Quote from Monkey_Man

    Can you still hear a difference, and if so, is this difference less than it was before?

    - Yes. I could hear the difference and the difference felt slightly smaller than before.
    If it's not my imagination:/


    Thanks a lot.


  • Power Cable Effects

    Thank you for your reply.:)


    I cannot have the exact same route because the cable lengths are different.
    I tried to reamp the same route as much as possible.

    I think you're right.
    I was surprised that the condition of the cable changed so much.

    3 and 4 are photographed.

    5 and 6 are the cables lifted to avoid touching the floor.







  • Power Cable Effects

    Hi guys!


    I tested whether the power cable affects the sound of the Kemper.

    I changed only the power cable and reamplified it. (SPDIF Connected)

    I used a normal cable and Oyaide L/i50 G5.


    The impression I got from the recording was that it has a slightly more treble than the normal cable and,

    when I connected it to the H&K Triamp mk2 power amp in the studio, I could feel the difference more clearly than the recording.

    I felt that the change was a little close to that of tube amplifiers.

    I didn't expect the power cable to affect Kemper.=O


    It doesn’t mean that expensive power cables are better.

    However, it may be too early to tell kemper that the power cable has no effect without trying it out yourself.


    I'm sorry if it's hard to read because I used a translation software.

    Thank you for reading!!^^