that´s right, but be aware that there are different versions of 7.1.5, one for the stage and one for toaster and rack.
Can i upgrade this with USB without using the rig manager?
that´s right, but be aware that there are different versions of 7.1.5, one for the stage and one for toaster and rack.
Can i upgrade this with USB without using the rig manager?
Greetings, guys, and gals.
I'm sort of old man in terms of Kemper usage, so basically, I didn't update the OS since the day I bought my toaster back in 2016
And never installed the rig manager....
I would like to upgrade the whole thing to the news versions.
From some brief checks, I realized that I have to take few steps and upgrade to a higher version every step till the newest one.
But for now, I'm kinda lost in which one to install first.
Now I'm on OS 3.3.0
As far as I understood, from here I can update to 7.1.5 and then to the newest one? Or I got it wrong?
Would like some advice on how to proceed with it properly and which version of rig manager should I install with the first step of the upgrade.
Any advice would be appreciated.
Thanks!
Thank you all! I'll definitely will write down some feedbacks after the tour!
My proposal - I also use only mono signal to FOH. (the other is not conected) Main is set to mono
One cable (L or R) to the FOH (Mono-Input)
Second cable to the other Gear
Monitor out to monitor
Thought so, just wanted to be sure.
Thanx!
Thanx for the warm welcome, mates!
Cheers
Good day mates,
I've been reading a lot in forum here and learned about the Kemper even before i got it physically.
But few details i didn't figure out yet and will be gratefull for your confirmation of what i did figure right
I gonna use Kemper on tour on this format:
1) Main Output XLR - > into the FOH
2) Monitor Output -> return of the amplifier with cab on stage to use it as my monitor on stage.
3) Main Output 1/4 left to monitor mix for other band mates IEM (i'm not using IEM).
Questions/Suggestions:
1) As i understood from the feedbacks here, the better solution is to use the Main XLR Outputs set on Mono mode. In this case still needed to use both XLR cables L and R or should use only one XLR cable from Left XLR output?
2) If i'm using Monitor output with the amp (as poweramp since i have an unpowered KPA) should i use it without the cab simulation and unlink the Master Volume knob in order to control the Monitor volume with it? Cab simulation shut down should be done in Output menu?
Thanx in advanse!
Cheers
Thank you!
Hammerfall (live)
Sabaton (live and studio)
Testament (Eric Peterson only)
Amon Amarth (live and studio)
Kataklysm
Hey mates!
Finally got my Kemper before going on tour. Have it two days only but completly dig it and no sleep since then haha. Have a two weeks to prepare it to the hard work and will share the profiles i made a bit later.
Great, effective and helpfull community you have here, mates.
Cheers
Sergei