Top Jimi got some good Slash tones.
Im using an eucatex (perforated panel) and some plastic clamp. Fixed Kemper Controller and a mission expression.
Everything inside a case.
Left a second expression without clamp, since It didnt fit side by side inside the case.
Easy, cheap and customizable.
Zoom converters are entry level. Sure It will sound poor than Kemper headphones
Check if the slot are enable.
Do a cable check. SPDIF must be shielded cable.
Used Troy Ellis to make this vídeo.
Hope you enjoy It.
It was an attempt, since I'm still learning It.
Class D power stages deliver certain power across certain loads. If you turn it to max volume on a 4 ohm cab it will try to deliver 1200 Watts exceeding the limit.
The power amp has a 6 dB boost to reach maximum 600 Watts of power. This means technically, if you limit this boost to 3 dBs or less with a 4 ohm cab it should not exceed 600 Watts. (Every 3 dB doubles the power)
The correct Power boost is 12db
I did a stress test onto poweramp section sometime ago to check mine. Put a dumb load (that could reach 1000w) and pushed It to 600w hard, monitoring via oscilloscope.
After a few minutes of work It starts to force protective shutdown and a brief clip at senoidal wave occurs. But It starts to work again almost imediatelly. It was a no audible test for sure. Don't try this at home
Icepeak poweramp os very reliable.
One performance per song, with bpm correct match and going from part A, B, C, D into each slot.
Just performing original songs.
Custom intelligent pitch scales are often used.
Using expression to controll EQ to simulate a moving filter, very, very interesting and fun to see people face they listen to it.
Mission (wah/volume) and Moog into expression (delay, pitch, move EQ parameters).
It's the right floor unit. Period.
Have you checked or changed speaker cable?
Removed by user
Technically speaking, you don't have any option other than to 'Save As' - whether your edit the settings, rename or not.
Was written by mind, without profile in front.
But you got It, don't you?
I'll continue to share profiles inspired by PAW tones under "eugtone". Enjoy. Comments and questions welcome.
Hey ejdeon, impressive research and work. Congrats.
Please check my delay preset for Ballerina. Hope you like it. Feel free to use it.
Insert "Chromatic Pitch'" into "MOD" slot
Voice 1 Picth: 9
Voice 2 Pitch: 5
Voice Balance: 0
Insert "Two Tap Delay" into "DELAY" slot
Delay Time 1: 180ms
Delay 2 Ratio: 50%
Low Cut: 20.6 hz
High Cut: 33488.1 hz
Reverse Mix: 0
Flutter Intensity: 0
Flutter Rate: 0
Or....you can setup, rename and "save as" the favorites ones to taste :
01 Green Stomp
05 Reverb 1
06 Reverb 2
So they appear first and you can select them in small list context.