Posts by JasFasola

check page 3 from that pdf,

there is some info how to convert signals 1 and 2, to mono. find bridge W400 and w401.

i’ve desolder that bridge and solder 2 way switch.

if i wanna use Btl, mono mode, just set correct position of that switch and connect main out xlr left to icepower input 1, and then same main out xlr fight from kemper to icepower input 2, but with modified xlr cable, just replace two hot wires inside.

you can see some about that on page 22 of that pdf.

i hope it’s clean how i wrote lol

see here:

back, back panel

yeah, agree about icepower,

i’ve got diy mod with my unpowered kemper, i’ve use icepower 50asx2 board, its stereo 2x50W class D amp.

I did some mod and can switch between stereo 2x50W for around 2 ohm or mono 170W in btl mode. I don’t remember specs but you can find some here:

https://static.qobuz.com/info/IMG/pdf/icepower50asx2.pdf

same question here, I’m looking something similar.