Posts by normtailor
-
-
I've never owned a Matchless Chieftain, but if I did I think I'd want it to sound like "Matchless Chieftain 1996 Clean 2" by StoneGroove. Punchy and chimey through my FRFR. Nice one!
-
Don’t feel bad, Mick and Dan on “That Pedal Show” have gone over this very phenomenon more than a few times. Makes a lot of sense once it clicks for you. Then you learn to use a treble boost post-stack, a few EQ tricks, and then we all start clamoring for more slots in the “Effects” section, lol. It’s a good problem to have, right?
-
Thanks Burkhard I had forgotten that existed. I'll give it a go.
-
Thanks, paults. I guess that’s probably what I’ll do. Just seems more logical to “roll back to decrease” but I’m sure I can adapt, even at my age…
As a side note, I had made a set of performances and said, “That’s it, no more tone chasing, only practicing!” Then I read the thread about putting the treble boost after the stack (hence the question), and suddenly a whole folder of rejected rigs came to life and demanded to be heard again. I guess I’ll never be truly cured, idk. Maybe time to stop reading, lol. -
Hi and thanks to all the great folks here!
Just getting started with morphing. My goal is to have a treble booster "always on" at 50% mix but be able to pull the mix down as needed when switching rigs. I've got "heel down" at 0 and "toe down" at 50%. Responding appropriately. However, when I change rigs the mix resets to 0%. If I keep the pedal mainly in the "toe down" position, that means I have to rock it back and forth into position with every rig change. I would like to keep my pedal toe down and have the initial mix at 50% when I switch to a new rig. I'm sure I'm missing something obvious, and appreciate anyone pointing it out to me. Thanks!
Mike
-
Thanks, that's good to know. I'll keep that in mind if I stumble across another behavior that seems inconsistent. Have a good one!
-
OK, that was dumb of me. I had it set at 0 instead of assigning a proper value. At -5, it works exactly as it should. Thank you for your time!
Mike
-
Thanks for jumping in! I have done what you suggested, but the pedal still is not changing volume.
-
Hey folks!
I can't seem to find this one, apologies if it's already been asked and answered. I have a Kemper unpowered rack and a FCB1010 with UnO for Kemper 1.4. All has been fine until I recently decided to take advantage of Performance Mode, which I hadn't been using to this point. I've made several performances and the FCB1010 is controlling everything as it should, including the left pedal assigned to Wah. The right pedal, which is assigned to Volume, now has no effect at all. Works fine in Browser mode. In "System Settings" Pg 5 (Pedal Links) the Volume slider (CC07) moves when I move the pedal so the communication is there.
I assume there is a box to tick somewhere, but I can't find it. Thanks in advance for any assistance!
Mike
-
Ha, your power over me is weakening lonestargtr . I was able to hold out for TWO DAYS before purchasing!
Great work as always and thanks!
-
I always found that the GUI looked amazing and my "eyes" were ready to be blown away, but then my "ears" got involved and meh, not so much. Imagine if Rig Manager had those sexy graphics, lol...
-
our buy 3 get 5 deal is on sale as well! 20 bucks for 5 pack
Hi,
I was just on your site but this deal does not apply when I check out. Is there a code to use? Thanks
-
I use the cab from DP\'65 Deluxe Crunc by Heater (rig exchange). YMMV obviously
-
"Look, it's fine. I don't even want it anymore, ok?"
(Wife logic . Works on me 100% of the time)
-
Not a doctor, but sounds like my thoughts when my GAS (gear acquisition syndrome) is acting up. Of course with the Kemper it's more of a PAS (profile acquisition syndrome) situation. I know I can take antacids for GAS, but I'm afraid my PAS may be incurable. Unless there's an antibiotic that kills my PayPal....
-
Quote...
This is how I wound up with a collection of "everything packs", tbh...also, no regrets
-
I think it can get even worse. I'll spend hours delightedly playing with a couple of rigs that have "my sound", then return to the same rig, same guitar, different day and wonder what the hell happened to make it sound so lame. Drives me crazy but I'm pretty sure the Kemper isn't the problem...maybe some Fletcher Munson corollary, I don't know, but I imagine it's a human problem.
Also, to your question, and although I have no sane reason for doing so, I bought an Atomic CLR Neo II wedge. Kinda pricey, but in combination with the Kemper, literally the most fun I've ever had. Really brought things to life in a way my headphones couldn't. No affiliation, just sayin'. My $0.02, hope you find your sound!
-
Lurker summary for new owners:
I read the entire thread
I watched the many videos of MBritt and others
I absolutely know I don't need any more profiles.
Therefore, if/when the next discount code comes out, I am emptying Mr. Britt's store... Thank you for all you do, sir!
That about sums it up, right?
#KemperLife
-
So when will I be able to buy "Noodle Like Sooze", ala Lick Library or Truefire? I need to do justice to all these great profiles! ?