Tried to update my toaster twice last night and at the end of the udate process i get a message in rig manager saying there was a problem and the update could not be completed. Anyone else experienced this and whats the solution?
Posts by inapier
-
-
I found this on the EurkaPROM forum, and I’ll try it and see what happens.
“The FCB1010 expression pedals can be finicky. Here's a procedure that helps force it to 0 & 127.
Calibrate again, but back off of the extremes.
For instance, during calibration, when calibrating the low value, move the expression pedal to the lowest position, but before pressing the UP pedal, raise the pedal ~5 digits worth - then press UP. When calibrating the top, move the expression pedal to the highest position, then lower it back ~5 digits worth, then press UP.
That should help.“ -
I can see the midi values being sent in the Kemper system menu. Both pedals go from 127 to 18 or 19.
-
I feel like there’s something I’m missing and that there’s a fix for this and I just need to figure it out. Both pedal’s lowest value is showing up as 19 in the Kemper and the odds seem low that both pedals would be broken and yet giving consistent readings between the two. This makes me lean in the direction of a setup issue. I have also disassembled the controller and made sure that the led and light sensors are properly aligned.
-
I went through the pedal calibration procedure several times and there has been no change.
-
Yes both pedals wont reach zero value
-
I recently acquired a FCB1010 with a EurekaPROM 3.2 to control my Kemper. After calibrating the expression pedals in the FCB1010 I noticed that the volume pedal would reach the maximum midi value of 127 but wasn’t able to reach a zero value in the heel down position. This was verified when I looked at the midi values for the pedals in the system settings. Is there any way to calibrate the midi within the Kemper so that my heel down position of my pedals becomes the new zero value?