i send the L and R signal to our snake splitter that then goes into our X32, routed to my IEM rig. I alter the monitor bus of my feed for my eq. The main bus is used for when we run sound for our own gigs, so i dont touch that until im in that room. I prefer to have it mounted with the mixer so i can have an actual IEM mix and not just only my guitar.
Posts by vhalen50
-
-
its unfortunate. I had it happen on my Axe FX2 and the MFC floor board. My MFC was repaired, out of warranty, for around 79 bucks i believe, but shipping both ways was nearly 60 dollars. Expensive repair. Thankfully fractal got the idea and revised the connection to Ethercon, and finally to XLR now.
one of the main reasons i went rack with the KPA was so that i could have a patch panel with a ethercon pass through to avoid this, id rather not go through that again. My buddy let me borrow his toaster though, and man is that portable.