Posts by BjornNilsson
-
-
-
I have done some instigation and found the problem:
The UAD arrow interface does not accept line level signal when a XLR lead is connected. Only TRS jack leads can be used for line level.
I tried it with a jack lead and it works fine so the problem is with the UAD.
Thanks for your inputs though!!
-
yes, the checked the output section and all volumes are fully up as well as the master volume on the front.
I'm assuming the Kemper sends line level
-
I have the same problem.
I connected the main outputs with balanced XLR cables to my UAD arrow XLR balanced inputs.
In line mode (which should be the right mode) I'm getting extremely low signals. In Mic mode I'm getting way too hot signals.
Volume on the Kemper is fully cranked up.