Hi and welcome....I still remember their first album!
Posts by jarabuandi
-
-
Hi and welcome!
-
Welcome GuitZero ...and well said: there is room for both.
-
The other thing is this "Kemper sounds bad at low volume ". What do yo mean by 'bad'? In general, a low volume dialled in tone doesn't translate well at higher volume and vice versa.
-
Hi, I'm sure it's just me but is the right click copy and paste option not a KPR thing? Sometimes i just want to copy an FX block from one performance to another and instinctually I go right click....no such thing.
-
Thanks mate, will give it a shot
-
Hi and welcome.
-
Welcome, glad you've found happiness!
-
Welcome and have fun with your new Stage.
-
Thanks Brian, much appreciated mate
-
-
Welcome mate!
-
played around a bunch more editing, copy pasting, renaming, turning Kemper on/off as well as rig manager. Mine is working great.
Maybe try a new USB cable? Or a different USB input on your computer if you have one. You are not going through a USB hub or anything?No hub. USB cable straight from my iMac to the Stage.....but just tested and when re-naming the Performance, now it changes on the Stage as well.
-
I works fine for me. The only hiccup was I had to name the performance twice before the name stuck.
I had to change performance and resell the the one I wanted to edit. Or I could not change the performance name again. The other odd thing is after I changed the name, I had to click anywhere below the name so that the Store Performance would highlight.I'll be home soon. Will start up my Stage and check if the Performance has synced.
-
going to go test mine again
Just to be certain, you are loading the rig into the (My profiler) performance and not (Local Library) ?yes
-
Did you save after the second performance slot ?
Yes, but nothing happens.
-
Hi all,
need some advice. I guess I'm doing something wrong but can't figure out how it should be done properly. So here it is.
In performance mode, New Performance. I want to create a new one. I know the rig I want (from another performance) so I copy that rig and paste it, say in the first slot of the new Performance. Now I store it using the Stage store function.
The RM (beta) and the KPR Stage both show the rig in slot one.
So far so good. Now i copy the same rig say in slot two and here's the 'funny' thing. I can see it in the RM but the slot on the Stage is empty. I've also tried copying the rig in a different slot but the stage still shows and empty slot.
Now another weird thing that happened was that I renamed new Performance to 'Cars' in RM but when i tried to rename 'Cars' to 'Cars tmp' the Stage didn't sync and kept the name as 'Cars'
Any advise would be very much appreciated
Cheers -
Im the opposite...always in 'Performance' mode. I use 'Browse' mode only when checking out rigs
-
Welcome, Joshua!
-
Welcome Jens.