Posts by JonyKp

Quote from tofudoom

Hi all, I found this thread because I'm having issues with the II footswitch on my Stage. Actually, this is my second stage. I bought my very first Kemper Stage about two weeks ago and received a unit with a particle stuck under the screen. I contacted Kemper Support about it and they asked that I exchange the unit for a new Stage.

So, just today I received the replacement and the II footswitch doesn't work! Here's a video: https://drive.google.com/file/…oPnAfQ8a/view?usp=sharing

I guess I'll have to contact support AGAIN. Frankly, this is very frustrating. If I knew I was going to have these issues going to a Kemper, I would have not made the switch.

Try adding a thick washer to the footswitch, it has worked for me

The same ìssue here with footswitch 3.

This is a hardware issue for sure, I think that is a problem with the heith of the switch, that it does not adjust perfectly.

I have repaired it just adding a thick washer so the heith varies, by the moment it is working right.

Hope this helps

Quote from skoczy

Hi JonyKp

Please use this page to report your issue. Describe, what happens, what's your software version, steps to reproduce the buggy behavior.

Done !... Thanks

I use to play with my Kemper stage directly to a small desk an then to a P.A .(Of course I use the CAB - ON output)

Yesterday I plugged it into a SEND tube amp and a speaker cab 2 x 12

Switching the cab to off the sound lose almost all personality and all the sounds tends to sound the same ....

That´s why I think how important is the Cab sound, just as important as the amp.

I don´t know if this exists because I am a new user but I think it can´t be done by now in Kemper...

it should be a must to have a WET mix CAB OUT option (as Axe or helix has)

So you could choose to bypass the CAB, or give more or less colour of the CAB in Kemper to the output signal to your power amp.

Please tell me what do you think and your experiences about it.

I have 2 computers : Win 8 - Win 10

In Win 8 doesn't crash but just do nothing, the screen remains as in pic 2

Win 10 CRASH .... (pic 1)

Rigs (Local Library) and says if I want to continue the program will skip the error and will try to continue, it continues but doesn't work right.

I can´t see the inspector on the left of the program with presets, rigs, performances ..... I see it in a very small screen as in picture 2.

Someone is experimenting the same issue?

Thank you for the responses (Damian, AdrianKe, DonPetersen) !,

Is not the easiest and quickest but it works. Yes, locking all the effects one by one can be stored in another rig copying just the effects. this was what I was looking for.

Anyway, of course it would be better to have a dedicated bottom ; copy all effects - paste all effects.

Locking the Stomp and Effects can be done?

So I have a rig in the bank 1-1 and I want to copy just all the effects to bank 2-2

Can you please explain how to just copy the effects?(Locking the Stomp and Effects method)

Sorry but I don´t understand how to do it .

Quote from DonPetersen

I was replying to DamianGreda 's post

Ok I see,........ sorry, hahahahaha

Quote from DonPetersen

why not one by one?

it only takes a few seconds.

Hi, I use almost the same effects in each rig, I just want to change the Amp-Cab.

The Stage does not let copy the entire effects rig an paste into another Rig.

I think this is possible in the other kemper products, why is this not possible in the stage?.

Is a headache to copy a effect one by one.

I think this is a must upgrade.

Thanks in advance !