Thank you very much! Liked.
Posts by Serjinio
-
-
-
Oops! I'm sorry. I didn't notice that the question was about the player.
-
Who's stopping you? In tuner mode there is a Reference Pitch option. I turned the knob and that was it. 424...456 Hz.
-
Does anyone know which version of Rig Manager contains the 'Tutorial Pitch Effects' rig pack?
The youngest on the site is 2.3.14 and it no longer exists. Clearly you need a version from 2018 or earlier. Where can I find it? -
There is no 'Tutorial Pitch Effects' rig pack in the Rig Packs folder.
It seems that it was removed from new versions of the OS.
Maybe someone will post it. Or someone knows how to find it.
-
Yes, same thing...
Someone already wrote about this. I haven't found a solution yet. You can only connect in access point mode. -
Thank you! Liked!
The clean channel is very good. -
Sad! USB audio is a very important feature.
-
-
-
LED lamps are so low-power, it’s crazy. They also last (basically) forever.
I’ve never heard a complaint that someone’s LEDs burned out.
Thank you Ruefus!
You almost put my mind at ease.
I'll get used to it, what else is left.
-
One flash at boot up seems normal to me.
¯\_(ツ)_/¯
Well, not sure if it's good for the screen and LEDs. Will this affect the resource of these elements. Judging by the brightness of the flash, the current through the LEDs is not small. Okay, if not.
-
The answer was:
"...this is intended behaviour, signalling the completed boot sequence. I hope you can adapt to the new status 🙂 ..."
It seems to me that in vain they added such an indication of the end of the OS boot. This bright flash is annoying. IMHO.
-
I wrote to support. While waiting for an answer.
-
When first turning on Kemper you should only see the LED screen on with "Kemper Profiler" and a progress bar underneath. Then it should load your last profile on the screen, or the last state it was in, and turn on the buttons and small LED's. There should be no flashing - at least not on the rackmount or toaster version. I would contact support. https://www.kemper-amps.com/contact
Thank you very much for your answer.
Everything is just like that. First, only the display with the loading indicator lights up with gradually increasing brightness, and then both the display and all LEDs flash briefly with high brightness. After that, the brightness drops to the set level in the system. Previously, after the OS was loaded, the display went out for a short time and the set brightness of all indicators was immediately set.
Thanks again.I will write to support.
-
Hello colleagues!
Prior to updating OC 8.7.20 to 9.0.5, when the KPA was turned on after the OS was loaded, the display went blank for a moment and then turned on, but its brightness and the brightness of all indicators were determined by the values specified in the system. I use approximately the average brightness of the display and indicators on my Stage. But now, after loading the KPA, the display does not go out, but flashes very brightly along with all the indicators, and only then the specified brightness of the glow is set. Personally, I don't like it. I usually work in the twilight and this flash is just scary. I would like to understand if this is a feature of my copy of the KPA or is it the same for everyone. I will be grateful for the information. -
-
-
This is cool! Thanks a lot. We look forward to continuing.
Just edit