Kemper is being selective about which rigs it wishes to import

Hey all!

I am going through the profiles and selecting the better half, renaming and replacing the entire Kemper profile with the updated versions. Over all this is working well but I have noticed that the Kemper says it has completed before in reality all the profiles are uploaded. Sometimes, just by deleting the profiles from the USB (that were uploaded properly) and leaving only the profiles that did not get imported, they are found and uploaded, other times I am finding it necessary to change the name before the Kemper sees it and imports it.

Anyone else ever run into this quirk?

Quote from deadpan

I had a similar problem when uploading from a USB flash drive. I reformatted it with the Kemper and all is well now.

Hmm, My USB stick was originally formatted but perhaps I should try reformatting it and see if this does the trick. Thanks for the idea Deadpan.

Quote from paults

These days, I've been selecting a list of rigs in Rig Manager, and dragging them into the Kemper.

Hey Paults, are you using a USB or are you uploading via the direct cable link up to your computer when doing this?